Spec

• [
  
  Common specification]
  
• Power voltage: AC100-120V/200-240V, 50/60Hz 20VA
• Operation temperature: 5 - 40℃
• Ambient humidity: 20 - 85% RH (non-condensing)
• Storage temperature: ?20 - 60℃
• Outer dimensions: (W) 200 x (H) 52 x (D) 172mm (excludes projecting parts)
• Mass: 1.5kg
• No. of control axes: 2 axes (2BG), 4 axes (4BG, However, simultaneous drive is up to 2 axes in the same group)
• Coordinate setting range: ±32,767
• Transfer rate: 1.5 - 100μm/sec
• Transfer rate settings: 32 step
• Pulse move distance: 1μm/pulse
• Interface RS232C: Connector D-Sub 9pin Female connector Inch screw, Baud rate 4800/9600/19200/38400, 8 bits data length, No parity, Stop bit 1 bit, Delimiter CR + LF/CR/LFNo flow control
• Interface GP-IB: Setting addresses 1 - 30, Delimiter CR + LF/CR/LF/EOI
• Interface USB: Support Full Speed mode, Delimiter CR
• Driver compatible motor: DC coreless servomotor
• Driver overload detection (over current detection): Is available
• Driver encoder signal: A and B phases, 1μm/pulse after multiplied by 2 on the driver side
• Driver limit sensor: + side, ? side limit (Direction to draw in the spindle is "?")
• Driver polarity: Normally closed
• Command name/revert to the mechanical origin: Command H: Return to the mechanical origin
• Command name/logical origin setting: Command R: Clear the current position coordinate
• Command name/speed settings: Command D: Set up transfer rate
• Command name/relative transfer drive: Command M: Relative position transfer drive
• Command name/absolute transfer drive: Command A: Absolute position transfer drive
• Command name/stop: Command L: Stop optmike transfer
• Command name/logical origin return: Command N: Return to the logical origin
• Command name/control commands: Command X: Lost motion settings
• Command name/device state confirmation: Command Q: check optmike coordinate
• Command name/controller state confirmation: Command ?: check controller state
• [Individual specification]
• No. of control axes: 2 axes