Spec

• 5V/1A lithium polymer (LiPo) battery charger
• This lithium polymer (LiPo) battery charger consists of a Microchip MCP73831 charge controller IC and a Diodes PAM2401 boost controller. The built-in protection diode allows multiple cells to be charged in series. While the booster circuit is in operation, the lower the input voltage, the more current can be drawn, so that a strong charge can be supplied in a short time. If a voltage higher than 5V is required, this board can be daisy-chained.
• [Note]
• *This board ***s a different IC than the SparkFun Power Cell and cannot be replaced.
• *Beca*** this board does not have low voltage detection or other battery protection features, we recomm*** that you *** it only with a battery with a built-in protection circuit.
• Get Started with the SparkFun LiPo Charger/Booster Guide
• Specifications
• Charger: microUSB, 500 mA
• Booster: 5 V, 1 A output
• 1,000mAh battery form factor
• Optional external battery isolation switch
• Enable Pin Disconnection
• Disable current less than 10 μA
• LED indicators for power and charge indication
• Clean output signal by high-frequency switching
• [Reference]
• Schematic
• Eagle Files
• Hookup Guide
• Datasheets
• MCP73831
• PAM2401
• GitHub
• RoHS Compliance